Basement Waterproofing and Crawl Space Repair in King George, VA

April 18, 2022 | King George, VA

Some fungal growth evident through crawl space. Liner on floor is damaged and not providing any protection from ground moisture. Remove damaged liner and dispose. Install new 8 mil liner on floor, wrap all columns and pin to walls 6 inches from floor. Apply sanitizing treatment to entire space. Customer and any pets need to be out of home during and up to 1 hour after treatment. This is a treatment and will not physically remove any fungal growth. However, any growth treated will be killed. Seal all vents. Install inducer in supply trunk. Reinstall pieces of insulation that have fallen.

March 04, 2022 | King George, VA

Water entering in multiple areas in utility room. Not related to foundation cracks but inspection shows ground water entry. Install GrateDrain system on front wall and left side wall, past existing sump crock and water pressure tank. Customer will need to remove pressure tank prior to work commencing. Install FlexiFlange to direct water under and into the system. Restore floor with concrete and flush ports. Tie in system to existing crock and flood test system.

December 29, 2021 | King George, VA

Remove drywall under right window to locate crack. Includes removal of bottom plate and a stud, if necessary, to complete work. Install Carbon Fiber crack repair which includes 2 part epoxy, clean surface of concrete foundation wall, application of carbon fiber patch system. Excavate floor where patch is to be applied, down to top of footer. Install Carbon fiber down below floor, back fill with type 57 and patch with concrete. Apply flexible concrete sealant to exterior crack at centerline of window down to soil line.

November 15, 2021 | King George, VA

Install GrateDrain system along rear wall from left inside doorway to right side edge of fireplace. Install Flexiflange and drill weep holes in the block pockets along entire length, back flush port be installed at the beginning of the run to permit servicing necessary. the customer may install flooring over the flush port but it is requested that it be left in a state that permits easy access. Install FastSump with liner in left corner of basement with high water alarm and clear check valve. Discharge line will be run up wall high enough to facilitate check valve installation then turn to run behind drywall to exit foundation on left side. Customer will install box to hid appearance of sump liner. Drywall will need to be removed where pipe runs up wall. Run discharge line under surface/under fence near landscape timber into flush mounted drain box.